Hello,
I'm struggling for quite some time now, trying to let a D-link dir-655, the tunnel work together on a windows 7/64 platform. The tunnel itself works like a charm, when I use it without the dir-655. Therefor I must be doing something wrong in the programming. attachted I send you everything known to me and I hope very much that someone can give me suggestions.
further
more
last
If you're running the tunnel on your dlink, why do you also have it on your computer? (First picture)
Remove the tunnel from the pc
OK thank you, have removed that but it still doesn't work. Can you give me an other suggestion???
What does the output of ipconfig /all show?
Hi,
There are som small changes in temp ipv6 adress and the local link. It seems funny to me that there is a perc symbol.....
The percent symbol identifies the interface
Everything here looks fine. Are you able to ping the IPv6 address of the router?
Yep no problem
C:\Users\Niek>ping 2001:470:1f15:70e::1
Pingen naar 2001:470:1f15:70e::1 met 32 bytes aan gegevens:
Antwoord van 2001:470:1f15:70e::1: tijd<1 ms
Antwoord van 2001:470:1f15:70e::1: tijd<1 ms
Antwoord van 2001:470:1f15:70e::1: tijd<1 ms
Antwoord van 2001:470:1f15:70e::1: tijd<1 ms
Ping-statistieken voor 2001:470:1f15:70e::1:
Pakketten: verzonden = 4, ontvangen = 4, verloren = 0
(0% verlies).
De gemiddelde tijd voor het uitvoeren van één bewerking in milliseconden:
Minimum = 0ms, Maximum = 0ms, Gemiddelde = 0ms
Sorry, I didn't see this earlier
Look at reply #3, the second picture
The LAN and WAN addresses can't be the same....
Indeed you're right. Now how doe I change that??
Go back into the dlink and make the WAN end in ::1
This is getting really scary. Without doeing anything this is the new scheme of ipv6 connectings
You changed the wrong thing
Here's what mine looks like
I'm sorry but as I tryed to explain in my previous reply. Without any doing on my behalve dir 655 changed the ipv6 connection info as shown on attachment, it even created one of my pc's as a ipv6 pc. So it wasn't me. Looking at your attachment I don't see much difference and if your dlink works and mine not, I do think I've got a problem. Would it be useful to reset the router and start from scratch??
I'm not sure i follow you, but yes, if your computer was getting an address from itself rather than the router, your info may have changed.
I think a reset may be a good idea
OK let you know what happens
Well I resetted the router, cleaned my network setting and strarted over. The result is the same, it just won't work. Now I think I downloaded the wrong firmware 2.05, maby it isn't mend for Europe I don't know. In contact with D-link NL to find out if my theory is right. Thank you for all the help
Does your router have receive a dynamic IPv4 address? I don't know if the 655 has the same problem as the 615, but with the 615, when the IPv4 address changes, one has to manually edit the IPv6 address setup to match the change.
Hi thanks for your reply. I considered this post as ended and therefore my late reply. Luckily I don't have a dynamic ipv4 address and I don't know if the Ipv6 address must be put in manually in normal circumstances. I did it manually, but as I stated earlier I may have put in the wrong firmware. I already send the DIR-655 back as a DOA and in 2 weeks I'll try again....