Print Page - Config in Vista SP1

Title: Config in Vista SP1
Post by: ipvsixfreely on July 31, 2008, 05:05:28 AM

Hello.

I tried to configure a tunnel in Vista today with no luck. I've run cmd as administrator, and issued the following commands:

Code Select


netsh interface ipv6>add v6v4tunnel IP6Tunnel 172.16.100.100 72.52.104.74

netsh interface ipv6>add address IP6Tunnel 2001:470:1f04:fe::2
The filename, directory name, or volume label syntax is incorrect.

As you can see, the first command worked fine, the second one is giving me an issue.

Any suggestions?

Title: Re: Config in Vista SP1
Post by: telepathy on August 11, 2008, 10:01:24 AM

Same issue here... Any solutions?

Title: Re: Config in Vista SP1
Post by: trim99 on February 02, 2009, 08:34:55 PM

Did you ever find a fix for this?

I am having the exact same issue

Title: Re: Config in Vista SP1
Post by: rfults on April 24, 2009, 07:16:23 PM

same issue on my Vista SP1 box... guess I am going over to linux.

Title: Re: Config in Vista SP1
Post by: rfults on April 24, 2009, 08:00:17 PM

Well I got it working, after deleting everything and typing it in. Copy and paste was screwing me up. Still can't access IPv6 sites...

Hurricane Electric's IPv6 Tunnel Broker Forums

General IPv6 Topics => IPv6 on Windows => Topic started by: ipvsixfreely on July 31, 2008, 05:05:28 AM