Hi All,
I have used the configuration provided by the tunnel "Example Configurations" tab and i still have no joy, neither the router nor my lan clients can access any external IPv6 resources.
Network Topology is as follows
WAN>>EDGE(Vyatta)>>LAN ROUTER>>CLIENTS
we have BT Infinity so our vyatta edge device receives a DHCP assigned address but we do have a public static-ip range that points to it.
The Edge router is set to nat all traffic for the tunnel ip and send it to the lan router.
I can't for the life of me figure out whats going on ???
anyone have any ideas?
Is your router passing protocol 41
To give me a better idea about what is going on, could you try setting 80.167.222.169 as your tunnel server and then try to ping 2001:470:28:940:de6e:7f3e:5430:8ed8? It is not a real tunnel server, so it won't work for general traffic, but it can reach that one IPv6 address.
My router is not behind NAT. I have a unique public IP. I think the setup till router is ok as I can ping IPV6 address from router's (Dlink DIR-615) web interface. But cannot connect from the Windows PCs.
Any suggestions?
Did you try to ping 2001:470:28:940:de6e:7f3e:5430:8ed8?
IPv6 Connection Type : IPv6 in IPv4 Tunnel
Network Status : Connected
WAN IPv6 Address : 2001:470:18:1292::2/64
IPv6 Default Gateway : 2001:470:18:1292::1
LAN IPv6 Address : 2001:470:19:1292::1/64
LAN IPv6 Link-Local Address : fe80::baa3:86ff:fe4a:43e/64
Primary DNS Address : 2001:470:20::2
Seccondary DNS Address : none
These are my settings on the dir 615 router