Hi guy's, fairly new to IPV6 and in need of a little help ;D . I have a home lab of several Cisco routers and switches, one of which is hooked up to a tunnel. I have no problem in setting up a lab which is all on the same subnet but when i create a 2nd subnet simulating a remote office trying to access the ipv6 internet through the office with a tunnel i cant get out. With ipv4 i would just use nat to translate my private address to my global address, does anybody now how i can do the same thing using ipv6? Should also mention that i can ping all interfaces from the remote office including my side of the tunnel, which is set as the default gateway, i just cant get out onto the ipv6 internet from the remote office :'(
Any help would be fantastic guys :)
sitting at your remote offuce, can you ping the interface where the tunnel is? can you ping past that? how are you assigning addresses?
Hi,
I can ping the interface of the tunnel from the remote office but cant ping past it, The ip address of the tunnel that was provided is 2001:***:1F08:537::2/64 and they gave me a 2001:***:1F09:537::1/64 to route which i have tried to subnet by giving the lan a subnet of 2001:***:1F08:537:1::/80 and the remote office subnet 2001:***:1F08:537:2::/80.
Is it possible to get out onto the ipv6 internet from a different subnet?
Hope this helps and thankyou for your help so far :D
So, to simulate the remote office, are you simply using TWO HE tunnels, one to each router? Or are you establishing a 6in4 tunnel between the routers directly?
Are you establishing static routes to your subnets on each router?
Also, the problem might be the fact that you're using /80s. The convention for IPv6 is that /64 is the longest prefix used, because automatic address configuration requires a /64. Technically, there's no reason that you shouldn't be able to use a /80, but I've never been clear on whether it's "legal" longer prefixes than /64, or if doing so creates interoperability problems with various equipment, etc. So it's best to stick with /64s.
If you are using two tunnels, HE should be able to route your traffic between the separate /64s via the tunnel servers no problem. But in a scenario like that, I'd just establish my own 6in4 between the two "offices" for direct connectivity, and use the HE tunnels for internet.
If you're using a single tunnel to one router, and establishing a tunnel to a second router via your own 6in4 tunnel, I suggest allocating a /48 from HE, and using /64 subnets of that and see if it works. Use another /64 for the tunnel end points if you want them to be reachable from the internet (you'll have 64K /64s, so no problem).
Thanks for all your help guys, Changed my addressing, had a 64/ on one interface where it should have been an /80. It's all routing Ipv6 as sweet as a nut now :D It's amazing what a little bit of help from you guys and a nights sleep can do :)
Thanks to all