• Welcome to Hurricane Electric's IPv6 Tunnel Broker Forums.

Tunnel and Lan Network

Started by bzuchowicz, November 16, 2011, 06:53:13 AM

Previous topic - Next topic

bzuchowicz

Hi!
I have a problem.I configure Cisco Router and I compare tunnel 6to4. I assume account in www.tunnelbroker.net and I get IPv6 address. I typed into the router configuration, exactly:
configure terminal
interface Tunnel0
description Hurricane Electric IPv6 Tunnel Broker
no ip address
ipv6 enable
ipv6 address 2001:470:1f14:1f28::2/64
tunnel source 212.182.73.42
tunnel destination 216.66.84.46
tunnel mode ipv6ip
ipv6 route ::/0 Tunnel0

Router can ping ipv6.google.com and other website, but I can't ping ipv6.google.com from lan network. My network topology looks like this:http://zapodaj.net/d495476cde75.jpg.html
On the left I have got LAN Network, on the right Internet connection. I'm working on real hardware CISCO, I'm student. My question is: What can I do to the computer from the network on the left can communicate with the Internet? I suppose that the conduct NAT-PT but I can't do it. Can anyone describe to me what should be entered into the router to make this work? Thanks

cholzhauer

You're using the wrong ip on your inside router interface....use the routed /64 for that and assignan address from there

bzuchowicz

Can you give an example of any address? Or addressing scheme for network LAN?

cholzhauer

The address range is on your tunnel details page...look for routed /64

Your setup is easy...give each interface an ip in that range.  If you're doing static addressing, give your hosts the default gateway of the inside interface of your router...just like ipv4

bzuchowicz

My address range is 2001:470:1f15:1f28::/64, so the router interface that connects the LAN I write address 2001:470:1f15:1f28::2/64 because now I use the address 2001:470:1f15:1f28::1/64 on the interface facing the Internet on Fa0 / 0, host have got address 2001:470:1f15:1f28::3/64 ? And it will work? I have to do something else? Perform NAT-PT? Can only enter addresses, and so it will work?

cholzhauer

No..you have the wrong range. The /64 on your outside router interface needs to be different than the /64 on the inside interface.  Double check your tunnel info page.

Other than that, you have the right idea