Print

[user3636]

Hello community,

I am trying to set a '6in4 tunnel' on my FritzBox router.
I am now trying to figure out, which bits of information need to go in which fields.
In the setup dialog I am being asked for the followings bits.

IPv4 address of the tunnel endpoint
IPv6 address of the tunnel endpoint
Local IPv6 address
IPv6 prefix


And from the 'IPv6 Tunnel Endpoints' page I have the following bits.

IPv6 Tunnel Endpoints
Server IPv4 Address: xxx.xxx.xxx.xxx
Server IPv6 Address:
Client IPv4 Address: xxx.xxx.xxx.xxx
Client IPv6 Address:


I already managed to figure out the bits for the IPv4 fields.
However I don't know where to find bits for the following fields for local IPv6 address and IPv6 Prefix.

Thx for the help, user3636

[cholzhauer]

You match up the data you have from HE to the fields below.

Tunnel end points are given to you by HE
local ipv6 address is the client /64 given to you by HE
prefix is /64 (unless you signed up for a /48)