Hurricane Electric's IPv6 Tunnel Broker Forums

General IPv6 Topics => IPv6 Basics & Questions & General Chatter => Topic started by: mafische on September 22, 2017, 01:44:46 PM

Title: Packet loss <->
Post by: mafische on September 22, 2017, 01:44:46 PM
Hello all,

in two locations I'm running separate 6in4 tunnels on top of standard DSL lines, working seemingly fine individually. The first, running already a couple of years, is terminating in OpenWRT, and in the second one, terminating on OPNsense, I had to adjust the standard MTU, but otherwise no obvious issues.

When I try direct IPv6 ssh connections from one site to the other (Berlin POP -> Frankfurt POP) the reproducible effect is that the connection dies after some time with continuous traffic (~10 secs). IPv4 always works fine. Only in the traceroute.

I can trace on both ends and putting the wireshark windows side by side I see missing packets and following retransmissions, DUP Acks. There's no issue with packet sizes, everything only a few hundred bytes.

Can anybody give me a hint how to debug this any further? Or has experienced similar problems? If needed, I can provide the traces.
Title: Re: Packet loss <->
Post by: matthiaspfaller on October 24, 2017, 01:05:37 PM

you seem to be located in germany, so you might be affected by

regards, Matthias