Hurricane Electric's IPv6 Tunnel Broker Forums
General IPv6 Topics => IPv6 on Routing Platforms => Topic started by: AnnieSyed on March 11, 2021, 07:14:48 PM
-
So I setup my tunnel on my MikroTik Router . I setup ipv6 on my trusted interface, in router mode, Added the prefix for my /48 addresses. Selected MTU, link layer address, allow transmission. My clients, are set with IPv6 autoconfiguration enabled. But the only IPv6 address I get is the link local.
What am I missing that is not allowing my clients to get an IPv6 address from my /48.
-
Have you setup router advertisements on your MikroTik?