Hurricane Electric's IPv6 Tunnel Broker Forums

Advanced search  


Welcome to Hurricane Electric's forums!

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - jervin

Pages: [1]
I'm trying to track down a problem where my Client IPv4 address in my account at tunnelbroker keeps changing from what it's supposed to be.  I'm sure it's something that I've done in the past but not sure what.  at least once a day, my IPv6 tunnel (6in4) goes down and I have to correct the Client IPv4 address in my record.  It keeps changing it to  I have the tunnel set up on my DD-WRT router.  And it works great until that address is changed.  then I have to run a little HTML thing to correct it, takes seconds but my ipv6 is down until I do. 

I do have a dynamic IPv4 address, but it hasn't changed in weeks.  The only thing I "think" i've done on DD-WRT is to have a command to allow the hurricane electric/tunnelbroker software to ping my router to verify the connection.

Next step is to change my password to try to rule out that it's nothing I'm doing.

IPv6 Software Applications & Hardware Appliances / DLink DIR-645
« on: November 19, 2012, 01:47:46 PM »
So, I think I've configured the IPV6 on my Dlink Dir-645, and my devices seem to be getting ipv6 addresses, but when I try to do something like "ping6", I get nothing coming back...  ie:  

jervin@Latitude:~$ ping6
PING 56 data bytes
--- ping statistics ---
11 packets transmitted, 0 received, 100% packet loss, time 10080ms

it even seems to be able to get the ip(v6) address of the url to be pinged.

Configuration is like this:
IPv6 in IPv4 Tunnel
Remote IPv4 Address:
Remote IPv6 Address: 2001:470:4:c5e::1
Local IPv4 Address :
Local IPv6 Address :2001:470:4:c5e::2
Subnet Prefix Length: 64

Primary DNS Server: 2001:4860:4860::8844 (OpenDNS)
Secondary DNS Server: 2001:4860:4860::8888

Lan IPv6 Address: 2001:470:5:c5e::/64
Lan IPV6 Link-Local Address:  fe80::ceb2:55ff:fefe:6fe0   /64

Enable Automatic IPv6 address assignment checked
Autoconfiguration: Stateful DHCPV6  (Could be SLAAC+RDNSS, or SLAAC+Stateless DHCP)

I had it working on my WRT54G with Tomato Software before it croaked and had to be replaced.

Oh Yes, the Status Screen for IPv6 says the following:

IPv6 Connection Information
IPv6 Connection Type : 6IN4
Network Status : Connected
Connection Up Time : 0 Day 0 Hour 55 Min 53 Sec
WAN IPv6 Address : 2001:470:4:c5e::2 /64
IPv6 Default Gateway : 2001:470:4:c5e::1
Primary IPv6 DNS Server : 2001:4860:4860::8844
Secondary IPv6 DNS Server : 2001:4860:4860::8888
LAN IPv6 Link-Local Address : fe80::ceb2:55ff:fefe:6fe0 /64
DHCP-PD : Disabled
IPv6 Network assigned by DHCP-PD : None
LAN IPv6 Address : 2001:470:5:c5e:: /64
LAN IPv6 Computers
IPv6 Address    Name(if any)


Pages: [1]