Hurricane Electric's IPv6 Tunnel Broker Forums

Advanced search  

News:

Welcome to Hurricane Electric's Tunnelbroker.net forums!

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - broquea

Pages: [1] 2 3 ... 113
1
Questions & Answers / Re: Cloudflare Blocked on Free Tunnels now?
« on: December 05, 2017, 07:36:26 AM »
We don't really discuss internal policy decisions.

2
Questions & Answers / Re: Cloudflare Blocked on Free Tunnels now?
« on: December 04, 2017, 05:24:35 PM »
Months ago.

3
IPv6 on Routing Platforms / Re: BGP Default Route Only
« on: October 17, 2017, 10:34:13 AM »
If you email ipv6@he.net and open a ticket, you can request the BGP session be set default-originate + full view, or default only.

4
Questions & Answers / Re: Pure Performance of tunnel to german endpoints
« on: September 26, 2017, 10:48:02 AM »
Frankfurt tunnels were migrated to Berlin temporarily while it gets a hardware replacement. Berlin also started suffering some load and loss, but we've done a little tuning and it should be looking better.

5
IPv6 on Routing Platforms / Re: HSRP with HE IPv6 Tunnel Broker
« on: September 16, 2017, 06:49:41 PM »
Not really. We have RPF in place upstream of your tunnel, so that tunnel's space is routed through it, not others. It'd almost be better to simply have a watchdog timer detect when a link goes down, update some dyndns entry and fire off an update to the broker for whichever IPv4 provider you use isn't down/offline.

6
Questions & Answers / Re: No reply from ipv6@he.net
« on: August 30, 2017, 09:03:53 PM »
That said: SAGE verified, IRC/SMTP enabled for the account. To remove the filters on your tunnel, log into the broker and remove them there on the Advanced tab under your tunnel's details.

7
Questions & Answers / Re: No reply from ipv6@he.net
« on: August 30, 2017, 09:00:26 PM »
If you never got an automated reply with a ticket #, then we never got your email.
The email address works fine.

8
As I mentioned in your trouble ticket, don't forget to install a pull-up route for your /48 either with a null route of the range, or configuring an IP out of it in an interface or loopback device.

9
Setting the MTU on our interface changes the MTU on OUR side. You still need to manually adjust the MTU on YOUR side.

10
Not at this time. Not certain if there will be a time.

11
We're not fans of numeric-only domains due to the huge loads of abuse they have generated in the past, so they aren't allowed anymore.

12
IPv6 on Linux & BSD & Mac / Re: IRC connectivity
« on: May 11, 2017, 01:21:34 PM »
Email was sent couple days back but there is no answer to it. So then i have to wait for their answer.

Did you get an automated reply with a ticket ID? If not, then your email didn't make it through. Email again, specify you have sage and provide your account info.

13
There.....is no HE tunnel in that config?

14
General Questions & Suggestions / Re: DNSSEC for slaves?
« on: March 10, 2017, 10:29:43 AM »
DNSSEC support is not available as of yet.

15
Questions & Answers / Re: tunnel down (endpoint Prague)
« on: February 22, 2017, 12:53:20 PM »
Right now, it seems fixed. The tunnel server of Prague is still emulated in Berlin, like before this outage. It seems that Prague server is gone for good.

Prague server is in Berlin until getting equipment bought in the US and shipped into the EU is made easier with customs. There are plans to replace the hardware in Prague and re-home the tunnels back to it.

Pages: [1] 2 3 ... 113