Dns won't work for me

[itsme2501]

Hello !  :)

I am not sure that i choose the good section but i think it can be.

I am using your service to discover how ipv6 works and to discover this new "ip world".

I have configured my tunnel on a cisco router, it's working great i can ping your server and other on the web.

So i move on my computer to configure my ipv6 and use the dns information show in the configuration pannel.

I try to go on internet, and nothing appear. I try to make nslookup, it didn't work too.
My windows computer is able to ping servers on the web.

Here is the configuration of my cisco :

Code Select Expand

ipv6 unicast-routing
!
!
interface Tunnel0
description Hurricane Electric IPv6 Tunnel Broker
no ip address
ipv6 address 2001:470:6C:B5E::2/64
ipv6 enable
ipv6 mtu 1280
tunnel source 192.168.2.17
tunnel destination 216.66.86.114
tunnel mode ipv6ip
!
interface FastEthernet0/0
ip address 192.168.2.17 255.255.255.0
ip virtual-reassembly
duplex full
ipv6 address 2001:470:6D:B5E::1/64
ipv6 enable
ipv6 traffic-filter test in
!
ip route 0.0.0.0 0.0.0.0 192.168.2.1
!
!
ipv6 route ::/0 Tunnel0
!
ipv6 access-list test
permit icmp any any log
sequence 11 deny tcp any eq 22 any log
sequence 12 deny tcp any eq telnet any log
sequence 30 permit ipv6 any any



On my computer:

Ipv6 Address : 2001:470:6d:b5e::5
Gateway : 2001:470:6d:b5e::1
Dns 1 : 2001:470:20::2
Dns 2 : 2001:4860:4860::8844

All my nslookup fail.

I don't understand what i am doing wrong.

Do you see any mistake on my settings ?

Thank you !

EDIT : Cisco is off actually, ping will fail if you check

[cholzhauer]

Maybe it's just me, but I'm having a hard time following what you're actually asking for help on...can you clarify?

[itsme2501]

Thank you for your reply.

I am just asking what i am doing wrong because i'm not able to use DNS.

Maybe i am using wrong addresses ? Or i miss something on my windows computer to use ipv6 dns server ?

All seems to work exept name resolution.

[cholzhauer]

So you want to use an IPv6 DNS server to look up addresses?  Are you asking how to add them in Windows?

Most IPv4 servers should be able to return both V4 and V6 addresses....