• Welcome to Hurricane Electric's IPv6 Tunnel Broker Forums.

Setup IPv6 Tunnel: IPv4 endpoint has been blocked

Started by nilayamoon, September 14, 2010, 02:10:12 AM

Previous topic - Next topic

nilayamoon

Hi there,

I've been trying to set up an IPv6 tunnel with your tool.
Somehow i can't get it to work, because something seems to be wrong with my IPv4 endpoint.
I get the error "Error: That IPv4 endpoint has been blocked (RFC1918 Private Address Space) "
That means i can't get an IPv6 tunnel to work if my computer is located in a Class A private network?

Greetings
Nilaya

kcochran

Quote from: nilayamoon on September 14, 2010, 02:10:12 AM
That means i can't get an IPv6 tunnel to work if my computer is located in a Class A private network?

Not by using your private IP, no.  You need to supply your public IP address, and then tell the NAT device you're using to forward proto41 onto your private IP, put your computer in the DMZ, or something similar, depending on what your NAT device is capable of.

We can't just route to your 10. address, since those routes don't exist on the public Internet.

nilayamoon

Quote from: kcochran on September 14, 2010, 02:18:05 AM
Quote from: nilayamoon on September 14, 2010, 02:10:12 AM
That means i can't get an IPv6 tunnel to work if my computer is located in a Class A private network?

Not by using your private IP, no.  You need to supply your public IP address, and then tell the NAT device you're using to forward proto41 onto your private IP, put your computer in the DMZ, or something similar, depending on what your NAT device is capable of.

We can't just route to your 10. address, since those routes don't exist on the public Internet.

So i guess that's a "no", because I don't have access to the network devices.. Guess i'll have to do these tasks on the weekends when I have a proper network available.