• Welcome to Hurricane Electric's IPv6 Tunnel Broker Forums.

News:

Welcome to Hurricane Electric's Tunnelbroker.net forums!

Main Menu

trouble with tunnel setup

Started by hexem, November 06, 2010, 10:55:27 AM

Previous topic - Next topic

hexem

Hi all,

Pretty new to setting up IPV6 tunnel's so take it easy.

I've followed the instruction's and config for windows 7 as generated by the site and everything goes through okay.

No connectivity, here's some output from my setting's (I'm behind a NAT device currently with no support for protocol 41)

(sure this doesn't look right, deff all the commands went through)

Tunnel adapter IP6Tunnel:

   Media State . . . . . . . . . . . : Media disconnected
   Connection-specific DNS Suffix  . :
   Description . . . . . . . . . . . : Microsoft Direct Point-to-point Adapater
   Physical Address. . . . . . . . . : 00-00-00-00-00-00-00-E0
   DHCP Enabled. . . . . . . . . . . : No
   Autoconfiguration Enabled . . . . : Yes

Publish  Type      Met  Prefix                    Idx  Gateway/Interface Name
-------  --------  ---  ------------------------  ---  ------------------------
No       Manual    256  ::/0                       32  2001:470:1f08:966::1


C:\Program Files\Windows AIK\Tools\PETools>netsh interface ipv6 show interfaces
IP6Tunnel

Interface IP6Tunnel Parameters
----------------------------------------------
IfLuid                             : tunnel_9
IfIndex                            : 32
State                              : disconnected
Metric                             : 50
Link MTU                           : 1280 bytes
Reachable Time                     : 40000 ms
Base Reachable Time                : 30000 ms
Retransmission Interval            : 1000 ms
DAD Transmits                      : 1
Site Prefix Length                 : 64
Site Id                            : 1
Forwarding                         : disabled
Advertising                        : disabled
Neighbor Discovery                 : disabled
Neighbor Unreachability Detection  : disabled
Router Discovery                   : disabled
Managed Address Configuration      : disabled
Other Stateful Configuration       : disabled
Weak Host Sends                    : disabled
Weak Host Receives                 : disabled
Use Automatic Metric               : enabled
Ignore Default Routes              : disabled
Advertised Router Lifetime         : 1800 seconds
Advertise Default Route            : disabled
Current Hop Limit                  : 0
Force ARPND Wake up patterns       : disabled
Directed MAC Wake up patterns      : disabled
Link-Layer Address                 : (my public IP)
Remote Link-Layer Address          : 216.66.80.26




Iv'e also applied an IPV6 address to my adapter, so not sure what's up, any help is appreciated.


cholzhauer

You said it yourself...your NAT device doesn't support protocol 41.  Because of that, you are unable to use a 6in4 tunnel, which is what HE provides

hexem

Thanks, figured it was something simple..  ::)