Hurricane Electric's IPv6 Tunnel Broker Forums

Advanced search  

News:

Welcome to Hurricane Electric's Tunnelbroker.net forums!

Author Topic: trouble with tunnel setup  (Read 2652 times)

hexem

  • Newbie
  • *
  • Posts: 2
trouble with tunnel setup
« on: November 06, 2010, 10:55:27 AM »

Hi all,

Pretty new to setting up IPV6 tunnel's so take it easy.

I've followed the instruction's and config for windows 7 as generated by the site and everything goes through okay.

No connectivity, here's some output from my setting's (I'm behind a NAT device currently with no support for protocol 41)

(sure this doesn't look right, deff all the commands went through)

Tunnel adapter IP6Tunnel:

   Media State . . . . . . . . . . . : Media disconnected
   Connection-specific DNS Suffix  . :
   Description . . . . . . . . . . . : Microsoft Direct Point-to-point Adapater
   Physical Address. . . . . . . . . : 00-00-00-00-00-00-00-E0
   DHCP Enabled. . . . . . . . . . . : No
   Autoconfiguration Enabled . . . . : Yes

Publish  Type      Met  Prefix                    Idx  Gateway/Interface Name
-------  --------  ---  ------------------------  ---  ------------------------
No       Manual    256  ::/0                       32  2001:470:1f08:966::1


C:\Program Files\Windows AIK\Tools\PETools>netsh interface ipv6 show interfaces
IP6Tunnel

Interface IP6Tunnel Parameters
----------------------------------------------
IfLuid                             : tunnel_9
IfIndex                            : 32
State                              : disconnected
Metric                             : 50
Link MTU                           : 1280 bytes
Reachable Time                     : 40000 ms
Base Reachable Time                : 30000 ms
Retransmission Interval            : 1000 ms
DAD Transmits                      : 1
Site Prefix Length                 : 64
Site Id                            : 1
Forwarding                         : disabled
Advertising                        : disabled
Neighbor Discovery                 : disabled
Neighbor Unreachability Detection  : disabled
Router Discovery                   : disabled
Managed Address Configuration      : disabled
Other Stateful Configuration       : disabled
Weak Host Sends                    : disabled
Weak Host Receives                 : disabled
Use Automatic Metric               : enabled
Ignore Default Routes              : disabled
Advertised Router Lifetime         : 1800 seconds
Advertise Default Route            : disabled
Current Hop Limit                  : 0
Force ARPND Wake up patterns       : disabled
Directed MAC Wake up patterns      : disabled
Link-Layer Address                 : (my public IP)
Remote Link-Layer Address          : 216.66.80.26




Iv'e also applied an IPV6 address to my adapter, so not sure what's up, any help is appreciated.

Logged

cholzhauer

  • Hero Member
  • *****
  • Posts: 2715
Re: trouble with tunnel setup
« Reply #1 on: November 06, 2010, 10:57:13 AM »

You said it yourself...your NAT device doesn't support protocol 41.  Because of that, you are unable to use a 6in4 tunnel, which is what HE provides
Logged

hexem

  • Newbie
  • *
  • Posts: 2
Re: trouble with tunnel setup
« Reply #2 on: November 06, 2010, 11:12:03 AM »

Thanks, figured it was something simple..  ::)
Logged