• Welcome to Hurricane Electric's IPv6 Tunnel Broker Forums.

Cisco Pix/ASA.. Where to place the firewall

Started by UltraZero, February 27, 2011, 10:11:41 AM

Previous topic - Next topic


Well, I am able to ping from the Firewall and from inside router.  I was missing a route command on the inside of the firewall. But, still can't access the network from the netwworks on the internal router.  Now, if I ping from the workstation, DNS works but, no pings are going through. I guess it's time to pull out a mini hub and put it between the workstation and router and sniff the packets. 


I fixed it... ;D ;D ;D ;D ;D ;D

Pix is up and running 

Come to find out after looking over and over and over code, reading books checking myself over and over
I found there is a  something different about these two commands

ip route interface
ip route next hop

what a pain in the  :o ??? ::)


I assume "interface" is the one that worked?


Actually, it didn't.  that is what I have thought all this time

The one that worked was the next hop..

I don't know why..

Simply one change and bang, up and running...