Welcome to Hurricane Electric's Tunnelbroker.net forums!
Started by peebles, January 09, 2013, 08:20:04 AM
Quote from: peebles on January 09, 2013, 08:20:04 AMtell me if I've missed something obvious.
Quote from: kasperd on January 10, 2013, 12:41:58 AMThe example configuration for the tunnel interface is incorrect. You are assigning an address from the routed /64 instead of the tunnel /64.
Quote from: peebles on January 10, 2013, 01:57:31 AMjust amended it.
Quote from: nickbeee on January 10, 2013, 06:45:10 AMI read it as 2001:DB8:8:7aa::1/64 dev eth0 for the LAN interface and address 2001:DB8:7:7aa::2 for the tunnel (on page 1).
Quote from: kasperdQuote from: nickbeee on January 10, 2013, 06:45:10 AMI read it as 2001:DB8:8:7aa::1/64 dev eth0 for the LAN interface and address 2001:DB8:7:7aa::2 for the tunnel (on page 1).The table in the start of the article looked correct. But further down in the actual configuration it was incorrect (but that has been fixed).
QuoteYou may want to consider using DHCPv6 to hand out IPv6 DNS servers to the clients - HE has 2001:470:20::2 and Google public DNS has IPv6 servers. You set the other stateful configuration flag in the RA's and then the hosts should be able to get their IPv6 DNS servers from DHCPv6.
QuoteMake sure your Pi and the corresponding switch port on the main router have negotiated a full-duplex connection otherwise you will see serious throughput problems. You can check this with one of the IPv6 speedtest sites such as ipv6-test.com or ipv6-speedtest.net
Settings for eth0: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Supported pause frame use: No Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Advertised pause frame use: Symmetric Receive-only Advertised auto-negotiation: Yes Link partner advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Link partner advertised pause frame use: Symmetric Receive-only Link partner advertised auto-negotiation: Yes Speed: 100Mb/s Duplex: Full Port: MII PHYAD: 1 Transceiver: internal Auto-negotiation: on Supports Wake-on: g Wake-on: d Current message level: 0x00000007 (7) drv probe link Link detected: yes
Quote# The MTU set on my router "negotiated via my ISP" is# 1492. So 1492 - 20 = 1472.# If your routers MTU is 1500, then you can just leave# the following line out, as it will default to 1480.mtu 1472