Print

[NickZeke]

Hello,

I am new to the site and trying to figure out where I am running into issues.  I recently setup my 1st IPv6 tunnel.  I had run into some problems with my ISP in regards to Protocol 41, but I corrected that on my router and was able to complete the setup.  However, I still cannot successfully perform any IPv6 tests.  Also, with my IP6 Tunnel, I cannot even ping my default gateway.

Looking for whatever help possible.

Thank you

[cholzhauer]

Let's start with what you've done so far

What commands have you ran?  What does your setup look like?

[NickZeke]

I executed the standard setup from the site for my Windows 8 Workstation:

netsh interface teredo set state disabled
netsh interface ipv6 add v6v4tunnel interface=IP6Tunnel 192.x.x.x 184.x.x.x
netsh interface ipv6 add address IP6Tunnel 2001:470:1f10:f48::2
netsh interface ipv6 add route ::/0 IP6Tunnel 2001:470:1f10:f48::1

Tunnel adapter IP6Tunnel:

   Connection-specific DNS Suffix  . : attlocal.net
   IPv6 Address. . . . . . . . . . . : 2001:470:1f10:f48::2
   Link-local IPv6 Address . . . . . : fe80::e51b:319d:8305:d767%19
   Default Gateway . . . . . . . . . : 2001:470:1f10:f48::1

[NickZeke]

Because I was blocked previously with my router, I'm trying to see if maybe more possible setting issues or even with my Norton 360 setup.

[cholzhauer]

Disable norton and see what you get.

Did you assign a /64 from your routed /64 to your Local Area Connection?

[mattwilson9090]

You said you corrected problems with Protocol 41 on your router. How did you do that? Did you do it by forwarding *Port 41* to an address somewhere in your network?