Hurricane Electric's IPv6 Tunnel Broker Forums

Advanced search  

News:

Welcome to Hurricane Electric's Tunnelbroker.net forums!

Author Topic: Error when setting endpoint  (Read 8453 times)

pikecom

  • readonly_member
  • Newbie
  • *
  • Posts: 1
Error when setting endpoint
« on: April 15, 2008, 08:54:43 PM »

I obtain the following error when setting endpoint. I need to know what host will be sending icmp requests to my endpoint to allow icmp requests from it.
Thanks


Error: Your IPv4 endpoint is unreachable or unstable. Please make sure ICMP is not blocked.


Fatal error: Cannot break/continue 1 level in /home/tb/public_html/includes/index_activate_tunnel.inc on line 52


Logged

broquea

  • Sr. Network Engineer, HE.NET AS6939
  • Administrator
  • Hero Member
  • *****
  • Posts: 1722
Re: Error when setting endpoint
« Reply #1 on: April 15, 2008, 09:42:28 PM »

I obtain the following error when setting endpoint. I need to know what host will be sending icmp requests to my endpoint to allow icmp requests from it.
Thanks


Error: Your IPv4 endpoint is unreachable or unstable. Please make sure ICMP is not blocked.


Fatal error: Cannot break/continue 1 level in /home/tb/public_html/includes/index_activate_tunnel.inc on line 52




tunnelbroker.net's ip is where the ping should originate.
Logged

joos13

  • Newbie
  • *
  • Posts: 2
Re: Error when setting endpoint
« Reply #2 on: November 13, 2008, 08:45:12 PM »

I am trying to set up a regular IPv6 tunnel.  When I enter my IP address (found from www.whatismyip.com), I get "Error: Your IPv4 endpoint is unreachable or unstable. Please make sure ICMP is not blocked."  ICMP echo requests were not blocked by my windows firewall, but I disabled my firewall anyways to see if the tunnel would succeed.  It did not work.  Any suggestions??  I don't have any experience with networking or IPv6.
Logged

broquea

  • Sr. Network Engineer, HE.NET AS6939
  • Administrator
  • Hero Member
  • *****
  • Posts: 1722
Re: Error when setting endpoint
« Reply #3 on: November 13, 2008, 08:57:19 PM »

I am trying to set up a regular IPv6 tunnel.  When I enter my IP address (found from www.whatismyip.com), I get "Error: Your IPv4 endpoint is unreachable or unstable. Please make sure ICMP is not blocked."  ICMP echo requests were not blocked by my windows firewall, but I disabled my firewall anyways to see if the tunnel would succeed.  It did not work.  Any suggestions??  I don't have any experience with networking or IPv6.

What is your IPv4 IP?
Logged

joos13

  • Newbie
  • *
  • Posts: 2
Re: Error when setting endpoint
« Reply #4 on: November 13, 2008, 09:12:21 PM »

My IP is 98.244.84.186.  Thanks for responding quickly :)

EDIT:

I created the tunnel, need to use 98.244.84.1 instead.  I ran the example configuration in the command line, though when I navigate to www.ipv6.org in IE, it says I am using an ipv4 IP address.  My firewall is off.  Any common mistakes I may be making?
« Last Edit: November 13, 2008, 10:20:10 PM by joos13 »
Logged