• Welcome to Hurricane Electric's IPv6 Tunnel Broker Forums.

Not getting the IPV6 Public IP address

Started by AnnieSyed, March 11, 2021, 07:14:48 PM

Previous topic - Next topic


So I setup my tunnel on my MikroTik Router .  I setup ipv6 on my trusted interface, in router mode, Added the prefix for my /48 addresses.  Selected MTU, link layer address, allow transmission.   My clients,  are set with IPv6 autoconfiguration enabled.   But the only IPv6 address I get is the link local. 

What am I missing that is not allowing my clients to get an IPv6 address from my /48.


Have you setup router advertisements on your MikroTik?