Print

[srijit92]

Recently I wanted to setup IPv6 for my home network. I signed up for tunnelbroker.net service and was provided with IPs. Then I configured the IP address in my DIR-615. But It's not working..

Screenshot of IPv6 config (router): http://i.stack.imgur.com/XTarm.jpg

Screenshot of my Win 8 network Config: http://i.stack.imgur.com/Y15W9.jpg

I also tested http://test-ipv6.com/ but failed...

Please help..

[snarked]

The only thing I noted that was different about your setup vs. mine with my DIR-615 is your LAN IPv6 address is set to the "::1" of your subnet, while I let my float to the natural MAC-generated address.

Try setting it to 2001:470:19:1292:BAA3:86FF:FE4A:043E and see if that makes a difference.

[srijit92]

No change. I cannot even ping a IPv6 fro mrouter's built in IPv6 ping utility

[srijit92]

After changing the Local IPv4 Address to 192.168.0.1, I can ping an IPv6 from router ping utility. But no luck on win setup...
Check attached images.

[cholzhauer]

Did you grab the newest version of the firmware?

[srijit92]

Yes I have it.

[snarked]

After changing the Local IPv4 Address to 192.168.0.1, I can ping....

Is your router behind another NAT device?  If so, that's the problem.

[srijit92]

No my router is not behind NAT. I have a unique public IP. I think the setup till router is ok as I can ping IPV6 from router's web interface.

[srijit92]

Anyone?

[snarked]

Your local IPv4 address for the tunnel should be your public IPv4 address.

[srijit92]

Its not same.
IPv6 Connection Type :   IPv6 in IPv4 Tunnel
Network Status :   Connected
WAN IPv6 Address :   2001:470:18:1292::2/64
IPv6 Default Gateway :   2001:470:18:1292::1
LAN IPv6 Address :   2001:470:19:1292::1/64
LAN IPv6 Link-Local Address :   fe80::baa3:86ff:fe4a:43e/64
Primary DNS Address :   2001:470:20::2
Seccondary DNS Address :   none

My ntwrk devices are not getting ipv6. But router can ping ipv6

[Jim Whitby]

In the ipv6 setup page.
Do you have the following options?

Enable automatic IPv6 address assignment :   
Enable Automatic DHCP-PD in LAN :   
Autoconfiguration Type :    
Router Advertisement Lifetime :      (minutes)

If so, try checking the boxes to enabled,
set the type to SLAAC+RDNSS
and lifetime of 1440.

[srijit92]

See my configurations :

Enable Autoconfiguration :   Yes
Autoconfiguration Type :    Stateful DHCPv6 
IPv6 Address Range (Start) :      2001:470:19:1292:0:0:0:2
Stateful (DHCPv6) :      : 2001:470:19:1292:0:0:0:ffe
IPv6 Address Lifetime:      30

[snarked]

Your local IPv4 address isn't your assigned globally reachable IPv4 address.

[srijit92]

Attached my TunnelBroker and DLink COnfigs. Please see my config and tell me If i need to change anything.